所有的設備都是有自己的使用壽命的，在長期的使用過程中，濟南油煙凈化器可能會因為維護清潔問題、操作不當問題、安裝不規范等原因在使用過程中出現故障。那么餐飲行業油煙凈化設備出問題我們應該怎么辦呢，今天小編就和大家分享一下油煙凈化設備維修指南。

All equipment has its own service life. In the long-term use process, Jinan lampblack purifier may fail in the use process due to maintenance and cleaning problems, improper operation, non-standard installation and other reasons. So what should we do if there is a problem with the lampblack purification equipment in the catering industry? Today, I will share with you the maintenance guide of the lampblack purification equipment.

一、油煙凈化設備出現了漏油

1、 Oil leakage occurs in the oil fume purification equipment

（1）先檢查油煙凈化設備內部是否沒有清洗，導致積油過多，出現滲油漏油的情況，如果是就要及時進行維護清洗。

(1) First, check whether the interior of the lampblack purification equipment is not cleaned, which leads to excessive oil accumulation and oil leakage. If so, timely maintenance and cleaning shall be carried out.

（2）檢查油煙凈化設備接口處密封條是否出現破損，如果密封條出現破損，請及時更換密封條。

(2) Check whether the sealing strip at the interface of the lampblack purification equipment is damaged. If the sealing strip is damaged, please replace it in time.

二：油煙凈化設備運行時出現聲響

2： Sound occurs when the lampblack purification equipment is running

（1）檢查油煙凈化設備電場的極針是否出現傾斜，若是電場的極針出現傾斜把極針給修正即可，出現這樣的情況大多都是清洗過程中不夠仔細或是清洗的方式不規范造成的，這樣就會導致油煙凈化設備出現連續較大的聲響，還會伴隨靜電火花。

(1) Check whether the electrode pin of the electric field of the lampblack purification equipment is inclined. If the electrode pin of the electric field is inclined, correct the electrode pin. Such situations are mostly caused by the careless cleaning process or the nonstandard cleaning method, which will cause the lampblack purification equipment to make a continuous loud noise, accompanied by electrostatic sparks.

（2）油煙凈化設備供電的電壓過高，電壓過高會出現連續的聲響，要是這樣的情況，就要調整電壓了。不建議用戶親自去進行操作，請讓人員來調整，避免影響凈化效率。

(2) If the voltage supplied by the lampblack purification equipment is too high, there will be continuous noise. In this case, it is necessary to adjust the voltage. Users are not recommended to operate in person. Please let professionals adjust to avoid affecting the purification efficiency.

（3）油煙凈化設備電場清洗后沒有晾干就使用了，這也會出現響聲，這樣的現像在晾干后就會恢復。

(3) The lampblack purification equipment is used without drying after being cleaned in the electric field, which also makes a noise. This phenomenon will recover after drying.

（4）油煙凈化設備的電場有雜質，在確認把油煙凈化器給清洗干凈的情況下依然出現很大的響聲，這一般都是里面出現了雜質，清洗后并沒有仔細檢查電場，里面出現了螺絲或者鋼絲等，取出就可以恢復正常了。

(4) There are impurities in the electric field of the lampblack purifier. After confirming that the lampblack purifier has been cleaned, there is still a loud noise. This is generally due to impurities in the lampblack purifier. After cleaning, the electric field has not been carefully checked. There are screws or steel wires in the lampblack purifier. Take it out and it can be restored to normal.

以上就是油煙凈化器比較容易出現故障的地方，也是用戶使用過程中容易出現的點，希望大家可以重視起來。更多相關內容就來我們網站http://m.jzfckj.net咨詢吧！

These are the places where failures of the lampblack purifier are easy to occur, as well as the points that are easy to occur when users use it. I hope you can pay attention to them. More relevant content will come to our website http://m.jzfckj.net Consult!